Opel Vectra A

since 1988-1995 release

Repair and operation of the car

Vektr's Opel And
+ 1. Maintenance instruction
+ 1.1 Maintenance
+ 2. Engine
+ 3. Repair of DOHC engines
+ 4. Repair of the diesel engine
+ 5. Cooling system
- 6. Fuel system
   6.2. General information
   6.3. Air filter
   6.4. The block of adjustment of temperature of the air coming to the engine
   6.5. Check of the fuel pump
   6.6. Removal and installation of the fuel pump
   6.7. Fuel tank
   6.8. Fuel level sensor
   6.9. Separator of vapors of fuel (l models 1,6 and 1,8)
   6.10. Accelerator pedal
   6.11. Accelerator cable
   6.12. Carburetor
   6.13. Removal and installation of the carburetor
   6.14. Adjustment of turns of idling and contents WITH
   6.15. Needle and float
   6.16. Vacuum diaphragm of a butterfly valve of the secondary camera
   6.17. Economizer diaphragm
   6.18. Accelerating pump
   6.19. Knot of the air automatic gate
   - 6.20. Vacuum blocks of movement of the air automatic gate
      6.20.2. Vacuum movement
      6.20.3. Solenoid of secondary movement
   6.21. Carburetor filter
   6.22. Adjustment of the shock-absorber of a butterfly valve
   6.23. Sensor of provision of a butterfly valve (automatic transmission)
   6.24. Valve check of increase in turns of idling
   6.25. The electromagnetic valve of idling on models of 1,8 l
   6.26. Inlet collector
+ 7. The fuel and exhaust system of models with system of injection of fuel
+ 8. Exhaust system and system of decrease in toxicity of exhaust gases
+ 9. Fuel systems of the diesel engine
+ 10. Engine electrical systems
+ 11. Transmission
+ 12. Mechanical transmission
+ 13. Automatic transmission
+ 14. Power shafts
+ 15. Brake system
+ 16. Suspension bracket
+ 17. Body
+ 18. Electric equipment
+ 19. Check of malfunctions


6.20.3. Solenoid of secondary movement


Arrangement of the screw of fastening of the solenoid of secondary movement and tire of grounding

1. The solenoid of secondary movement works together with the main block of a diaphragm.
2. Remove a weight wire from the accumulator.
3. On early models remove the air filter. On later models disconnect the air duct from the air filter, then disconnect a vacuum pipe and a hose of ventilation of a case from an air chamber. Unscrew three screws and remove an air chamber together with an air duct.
4. Disconnect a vacuum tube from the diaphragm block.
5. Disconnect the electric socket, unscrew the screw of fastening and remove the solenoid and an arm from the carburetor. Keep in mind that the screw of fastening of the solenoid also fixes the grounding tire электричес whom the socket (see the drawing).


1. Installation is made in the sequence, the return to removal. At screwing up of the solenoid do not forget to screw also the grounding tire.