Opel Vectra A

since 1988-1995 release

Repair and operation of the car


Vektr's Opel And
+ 1. Maintenance instruction
+ 1.1 Maintenance
+ 2. Engine
+ 3. Repair of DOHC engines
+ 4. Repair of the diesel engine
+ 5. Cooling system
- 6. Fuel system
   6.2. General information
   6.3. Air filter
   6.4. The block of adjustment of temperature of the air coming to the engine
   6.5. Check of the fuel pump
   6.6. Removal and installation of the fuel pump
   6.7. Fuel tank
   6.8. Fuel level sensor
   6.9. Separator of vapors of fuel (l models 1,6 and 1,8)
   6.10. Accelerator pedal
   6.11. Accelerator cable
   6.12. Carburetor
   6.13. Removal and installation of the carburetor
   6.14. Adjustment of turns of idling and contents WITH
   6.15. Needle and float
   6.16. Vacuum diaphragm of a butterfly valve of the secondary camera
   6.17. Economizer diaphragm
   6.18. Accelerating pump
   6.19. Knot of the air automatic gate
   + 6.20. Vacuum blocks of movement of the air automatic gate
   6.21. Carburetor filter
   6.22. Adjustment of the shock-absorber of a butterfly valve
   6.23. Sensor of provision of a butterfly valve (automatic transmission)
   6.24. Valve check of increase in turns of idling
   6.25. The electromagnetic valve of idling on models of 1,8 l
   6.26. Inlet collector
+ 7. The fuel and exhaust system of models with system of injection of fuel
+ 8. Exhaust system and system of decrease in toxicity of exhaust gases
+ 9. Fuel systems of the diesel engine
+ 10. Engine electrical systems
+ 11. Transmission
+ 12. Mechanical transmission
+ 13. Automatic transmission
+ 14. Power shafts
+ 15. Brake system
+ 16. Suspension bracket
+ 17. Body
+ 18. Electric equipment
+ 19. Check of malfunctions


24bec775


6.23. The sensor of provision of a butterfly valve on models with the automatic transmission

Removal

PERFORMANCE ORDER
1. Remove a weight wire from the accumulator.
2. Disconnect the electric socket from the sensor.
3. Unscrew two screws and remove the sensor from an arm. Also the sensor can be removed together with an arm.

Installation

Arrangement of the sensor of provision of a butterfly valve on models with the automatic transmission

1 – adapter;

2 – valve

PERFORMANCE ORDER

1. Installation is made in the sequence, the return to removal taking into account the next moments:

– install the sensor at completely closed butterfly valve and check that the adapter (1) (see the drawing) is correctly established on an axis of a butterfly valve;
– being careful, tighten fastening screws.