Opel Vectra A

since 1988-1995 release

Repair and operation of the car



Vektr's Opel And
+ 1. Maintenance instruction
+ 1.1 Maintenance
+ 2. Engine
+ 3. Repair of DOHC engines
+ 4. Repair of the diesel engine
+ 5. Cooling system
- 6. Fuel system
   6.2. General information
   6.3. Air filter
   6.4. The block of adjustment of temperature of the air coming to the engine
   6.5. Check of the fuel pump
   6.6. Removal and installation of the fuel pump
   6.7. Fuel tank
   6.8. Fuel level sensor
   6.9. Separator of vapors of fuel (l models 1,6 and 1,8)
   6.10. Accelerator pedal
   6.11. Accelerator cable
   6.12. Carburetor
   6.13. Removal and installation of the carburetor
   6.14. Adjustment of turns of idling and contents WITH
   6.15. Needle and float
   6.16. Vacuum diaphragm of a butterfly valve of the secondary camera
   6.17. Economizer diaphragm
   6.18. Accelerating pump
   6.19. Knot of the air automatic gate
   + 6.20. Vacuum blocks of movement of the air automatic gate
   6.21. Carburetor filter
   6.22. Adjustment of the shock-absorber of a butterfly valve
   6.23. Sensor of provision of a butterfly valve (automatic transmission)
   6.24. Valve check of increase in turns of idling
   6.25. The electromagnetic valve of idling on models of 1,8 l
   6.26. Inlet collector
+ 7. The fuel and exhaust system of models with system of injection of fuel
+ 8. Exhaust system and system of decrease in toxicity of exhaust gases
+ 9. Fuel systems of the diesel engine
+ 10. Engine electrical systems
+ 11. Transmission
+ 12. Mechanical transmission
+ 13. Automatic transmission
+ 14. Power shafts
+ 15. Brake system
+ 16. Suspension bracket
+ 17. Body
+ 18. Electric equipment
+ 19. Check of malfunctions



6.21. Carburetor filter

Removal

PERFORMANCE ORDER
1. The fuel filter in the form of a tubule is installed in the top cover of the carburetor.
2. You make replacement of the fuel filter through 30 000 km of a run or each 24 months.
3. Depending on model remove either the air filter, or an air chamber from the top part of the carburetor. Remove a fuel hose from the union of the top cover of the carburetor and close it a suitable stopper.
4. Take the fuel filter from an union opening for what use an edge of the thin screw-driver or screw in in the filter the screw with the M3 carving on depth of 5 mm.
5. If the fuel filter is strongly polluted or has damages, replace it. If the fuel filter in the normal state, blow it compressed air and wash out in pure solvent.

Installation

Installation of the fuel filter in a carburetor cover

PERFORMANCE ORDER
1. At installation of the fuel filter press it into an union opening before its accurate fixing (see the drawing). Further installation is made in the sequence, the return to removal.