Opel Vectra A

since 1988-1995 release

Repair and operation of the car

Vektr's Opel And
+ 1. Maintenance instruction
+ 1.1 Maintenance
+ 2. Engine
+ 3. Repair of DOHC engines
- 4. Repair of the diesel engine
   4.2. General information
   4.3. The repair which is not demanding removal of the engine
   4.4. Check of a compression
   4.5. Top Dead Point (TDP) of the piston of the first cylinder
   4.6. Cover of a head of the block of cylinders
   4.7. Pulley of a bent shaft
   4.8. Casings of a gear belt
   4.9. Replacement of a gear belt
   4.10. Check and installation of phases of gas distribution
   + 4.11. Mechanism of a tension of a gear belt and pulleys
   4.12. Replacement of a sealing ring of the camshaft
   4.13. Check and adjustment of gaps of valves
   4.14. Camshaft and pushers
   4.15. Head of the block of cylinders
   4.16. Oil pallet
   4.17. Oil pump
   4.18. Replacement of a sealing ring of the oil pump
   4.19. Oil heater
   + 4.20. Pistons with rods
   4.21. Flywheel
   4.22. Replacement of sealing rings of a bent shaft
   4.23. Replacement of support of the power unit
   4.24. Recommendations about removal of the engine
   4.25. Removal and installation of the engine
   4.26. Repair of the engine
   4.27. Start of the engine after capital repairs
+ 5. Cooling system
+ 6. Fuel system
+ 7. The fuel and exhaust system of models with system of injection of fuel
+ 8. Exhaust system and system of decrease in toxicity of exhaust gases
+ 9. Fuel systems of the diesel engine
+ 10. Engine electrical systems
+ 11. Transmission
+ 12. Mechanical transmission
+ 13. Automatic transmission
+ 14. Power shafts
+ 15. Brake system
+ 16. Suspension bracket
+ 17. Body
+ 18. Electric equipment
+ 19. Check of malfunctions

4.3. The repair which is not demanding removal of the engine

GENERAL INFORMATION

On the engine installed in the car it is possible to execute the following operations:

– check of a compression;
– removal and installation of the camshaft;
– removal and installation of a gear belt;
– removal and installation of a casing of a gear belt;
– check and adjustment of gaps of valves;
– removal and installation of the camshaft and pushers;
– removal and installation of a head of the block of cylinders;
– removal and installation of pistons and rods;
– removal and installation of the oil pallet;
– removal and installation of the oil pump;
– removal and installation of the oil heater;
– replacement of sealing rings of a bent shaft;
– survey and replacement of a suspension bracket of the power unit;
– removal and installation of a flywheel or plate of the drive.

home