Opel Vectra A

since 1988-1995 release

Repair and operation of the car



Vektr's Opel And
+ 1. Maintenance instruction
+ 1.1 Maintenance
+ 2. Engine
+ 3. Repair of DOHC engines
- 4. Repair of the diesel engine
   4.2. General information
   4.3. The repair which is not demanding removal of the engine
   4.4. Check of a compression
   4.5. Top Dead Point (TDP) of the piston of the first cylinder
   4.6. Cover of a head of the block of cylinders
   4.7. Pulley of a bent shaft
   4.8. Casings of a gear belt
   4.9. Replacement of a gear belt
   4.10. Check and installation of phases of gas distribution
   + 4.11. Mechanism of a tension of a gear belt and pulleys
   4.12. Replacement of a sealing ring of the camshaft
   4.13. Check and adjustment of gaps of valves
   4.14. Camshaft and pushers
   4.15. Head of the block of cylinders
   4.16. Oil pallet
   4.17. Oil pump
   4.18. Replacement of a sealing ring of the oil pump
   4.19. Oil heater
   + 4.20. Pistons with rods
   4.21. Flywheel
   4.22. Replacement of sealing rings of a bent shaft
   4.23. Replacement of support of the power unit
   4.24. Recommendations about removal of the engine
   4.25. Removal and installation of the engine
   4.26. Repair of the engine
   4.27. Start of the engine after capital repairs
+ 5. Cooling system
+ 6. Fuel system
+ 7. The fuel and exhaust system of models with system of injection of fuel
+ 8. Exhaust system and system of decrease in toxicity of exhaust gases
+ 9. Fuel systems of the diesel engine
+ 10. Engine electrical systems
+ 11. Transmission
+ 12. Mechanical transmission
+ 13. Automatic transmission
+ 14. Power shafts
+ 15. Brake system
+ 16. Suspension bracket
+ 17. Body
+ 18. Electric equipment
+ 19. Check of malfunctions


24bec775


4.22. Replacement of sealing rings of a bent shaft

Right sealing ring

PERFORMANCE ORDER
1. Remove a pulley of a bent shaft.
2. Drill two small openings located in the opposite ends of consolidation in a sealing ring. Screw in two I samonarezat shchy the screw in the drilled openings of a sealing ring and, using flat-nose pliers, extend a sealing ring for heads of screws.
3. Clear a nest of a sealing ring.
4. Oil pure engine working edges of a new sealing ring and establish it on a bent shaft. Working edges of a new sealing ring have to be directed inside.
5. Remove all traces of engine oil and establish a pulley on a bent shaft.

Left sealing ring

PERFORMANCE ORDER
1. Remove a flywheel.
2. Drill two small openings located in the opposite ends of consolidation in a sealing ring. Screw in two I samonarezat shchy the screw in the drilled openings of a sealing ring and, using flat-nose pliers, extend a sealing ring for heads of screws.
3. Clear a nest of a sealing ring.
4. Oil pure engine working edges of a new sealing ring and establish it on a bent shaft. Working edges of a new sealing ring have to be directed inside.
5. Establish a flywheel.