Opel Vectra A

since 1988-1995 release

Repair and operation of the car

Vektr's Opel And
+ 1. Maintenance instruction
+ 1.1 Maintenance
+ 2. Engine
+ 3. Repair of DOHC engines
- 4. Repair of the diesel engine
   4.2. General information
   4.3. The repair which is not demanding removal of the engine
   4.4. Check of a compression
   4.5. Top Dead Point (TDP) of the piston of the first cylinder
   4.6. Cover of a head of the block of cylinders
   4.7. Pulley of a bent shaft
   4.8. Casings of a gear belt
   4.9. Replacement of a gear belt
   4.10. Check and installation of phases of gas distribution
   + 4.11. Mechanism of a tension of a gear belt and pulleys
   4.12. Replacement of a sealing ring of the camshaft
   4.13. Check and adjustment of gaps of valves
   4.14. Camshaft and pushers
   4.15. Head of the block of cylinders
   4.16. Oil pallet
   4.17. Oil pump
   4.18. Replacement of a sealing ring of the oil pump
   4.19. Oil heater
   + 4.20. Pistons with rods
   4.21. Flywheel
   4.22. Replacement of sealing rings of a bent shaft
   4.23. Replacement of support of the power unit
   4.24. Recommendations about removal of the engine
   4.25. Removal and installation of the engine
   4.26. Repair of the engine
   4.27. Start of the engine after capital repairs
+ 5. Cooling system
+ 6. Fuel system
+ 7. The fuel and exhaust system of models with system of injection of fuel
+ 8. Exhaust system and system of decrease in toxicity of exhaust gases
+ 9. Fuel systems of the diesel engine
+ 10. Engine electrical systems
+ 11. Transmission
+ 12. Mechanical transmission
+ 13. Automatic transmission
+ 14. Power shafts
+ 15. Brake system
+ 16. Suspension bracket
+ 17. Body
+ 18. Electric equipment
+ 19. Check of malfunctions

4.21. Flywheel

GENERAL INFORMATION

Prevention

At installation of a flywheel it is necessary to use new bolts.

Removal

Fixing of a gear wreath of a flywheel from a provorachivaniye

Removal of the fixing plate from a flywheel

PERFORMANCE ORDER

1. Remove the transmission and coupling.

2. Record a flywheel from a provorachivaniye, having established a clamp on a gear wreath of a flywheel (see rice. Fixing of a gear wreath of a flywheel from a provorachivaniye). Apply a combination tag on a bent shaft and a flywheel.

3. Unscrew bolts and remove a flywheel (see rice. Removal of the fixing plate from a flywheel).

Check

PERFORMANCE ORDER

1. Check a flywheel for wear from coupling and a condition of teeths of a gear wreath of a flywheel.

Installation

Tightening of bolts of fastening of a flywheel

PERFORMANCE ORDER

1. Clear the interfaced surfaces of a flywheel and a bent shaft.

2. Put the means interfering unscrewing of bolts on a carving of bolts of fastening of a bent shaft.

3. Establish a flywheel according to earlier put tag and fix by bolts, having tightened them the required moment.

4. Remove a clamp of blocking of a flywheel and install the transmission.

home

QX4.ONLINE
S40.ONLINE
A-8.ONLINE
W124.ONLINE
RX300.ONLINE
W140.ONLINE
B3-B4.SPACE
B3B4.SPACE
A-8.SPACE