Opel Vectra A

since 1988-1995 release

Repair and operation of the car



Vektr's Opel And
+ 1. Maintenance instruction
+ 1.1 Maintenance
+ 2. Engine
+ 3. Repair of DOHC engines
+ 4. Repair of the diesel engine
+ 5. Cooling system
+ 6. Fuel system
+ 7. The fuel and exhaust system of models with system of injection of fuel
+ 8. Exhaust system and system of decrease in toxicity of exhaust gases
+ 9. Fuel systems of the diesel engine
+ 10. Engine electrical systems
+ 11. Transmission
+ 12. Mechanical transmission
+ 13. Automatic transmission
+ 14. Power shafts
- 15. Brake system
   15.2. General information
   15.3. Anti-blocking system of brakes (ABS)
   15.4. Pumping of the hydraulic brake system
   + 15.5. Replacement of front brake shoes
   15.6. Replacement of back brake shoes on disk brakes
   + 15.7. Replacement of back brake shoes on drum brakes
   15.8. Replacement of brake shoes of the emergency brake on back disk brakes
   15.9. Support of a forward brake
   15:10. Support of a back disk brake
   15:11. Brake disk
   15:12. Forward brake disk
   15:13. A back brake disk on models with SOHC engines
   15:14. A back brake disk on models with DOHC engines
   15:15. Brake drum
   15:16. Back working brake cylinder
   15:17. Brake board of a back brake
   15:18. Protection cover of a forward brake disk
   15:19. Main brake cylinder
   15:20. Repair of the main brake cylinder (model without ABS)
   15:21. Vacuum amplifier of brakes
   15:22. Hydraulic ABS modulator
   15:23. The ABS sensors installed on wheels
   15:24. ABS control unit
   15:25. ABS relay (only ABS-2E system)
   15:26. Valves of adjustment of pressure
   15:27. Brake pipelines and hoses
   15:28. Adjustment of the emergency brake
   + 15:29. Cable of the emergency brake
   15:30. Lever of the emergency brake
   15:31. Brake pedal
+ 16. Suspension bracket
+ 17. Body
+ 18. Electric equipment
+ 19. Check of malfunctions


24bec775


15:27. Brake pipelines and hoses

GENERAL INFORMATION

Brake tubes are applied to transfer of brake fluid from the main brake cylinder to wheel brake cylinders. Connections of tubes with brake cylinders and the distributor ny devices are made by conical couplings. The ends of tubes are pressed out and have the cone-shaped form for the corresponding size of conical carving openings in brake cylinders or distributing devices.

Before sinking of the ends of tubes the lock nut which after a vvinchivaniye of a cone-shaped surface in the conical basis of a carving opening presses and pressurizes a tube is put on them.

Brake hoses carry out mobile communications between mobile and motionless parts of the car. For reduction of losses of brake fluid at removal of working brake cylinders clips for a perezhatiya of brake hoses are used.

At installation of a new brake tube or brake hose be convinced that they are densely fixed in arms and are at sufficient distance from the moving or heating up details.

Upon termination of installation check the level of brake fluid in the main brake cylinder and add it if necessary. Remove air from the brake system and carefully check work of brakes before beginning operation of the car.