The device, service, repair Vektr's Opel And - 5.8. A radiator (models with the automatic transmission)//1988-1995 /

Opel Vectra A

since 1988-1995 release

Repair and operation of the car



Vektr's Opel And
+ 1. Maintenance instruction
+ 1.1 Maintenance
+ 2. Engine
+ 3. Repair of DOHC engines
+ 4. Repair of the diesel engine
- 5. Cooling system
   5.2. General information
   5.3. Antifreeze
   5.4. Washing of the cooling system
   5.5. Discharge of cooling liquid
   5.6. Filling of the cooling system
   5.7. A radiator (models with the mechanical transmission)
   5.8. A radiator (models with the automatic transmission)
   5.9. Check and cleaning of a radiator
   5.10. Thermostat
   5.11. Check of operability of the thermostat
   5.12. Water pump
   5.13. Radiator fan
   5.14. Broad tank and sensor of level of cooling liquid
   5.15. Sensor of the index of temperature of cooling liquid
   5.16. Radiator fan thermal sensor
   5.17. Control panel of a heater
   5.18. Heater radiator
   5.19. Heater fan engine
   5.20. Ventilation nozzles
+ 6. Fuel system
+ 7. The fuel and exhaust system of models with system of injection of fuel
+ 8. Exhaust system and system of decrease in toxicity of exhaust gases
+ 9. Fuel systems of the diesel engine
+ 10. Engine electrical systems
+ 11. Transmission
+ 12. Mechanical transmission
+ 13. Automatic transmission
+ 14. Power shafts
+ 15. Brake system
+ 16. Suspension bracket
+ 17. Body
+ 18. Electric equipment
+ 19. Check of malfunctions
24bec775 24bec775



5.8. A radiator (models with the automatic transmission)

Removal

PERFORMANCE ORDER
1. On models with the automatic transmission to the left of a radiator of the cooling system the heat exchanger of transmission liquid which is connected with transmission two flexible hoses with metal tubes on the ends is located.
2. At removal of a radiator, using clips, press flexible hoses of the heat exchanger of transmission liquid or unscrew hoses from the heat exchanger and close them traffic jams.

Installation

PERFORMANCE ORDER
1. Installation is made in the sequence, the return to removal. Check liquid level in the automatic transmission and if necessary, add.