Opel Vectra A

since 1988-1995 release

Repair and operation of the car



Vektr's Opel And
+ 1. Maintenance instruction
+ 1.1 Maintenance
+ 2. Engine
+ 3. Repair of DOHC engines
+ 4. Repair of the diesel engine
- 5. Cooling system
   5.2. General information
   5.3. Antifreeze
   5.4. Washing of the cooling system
   5.5. Discharge of cooling liquid
   5.6. Filling of the cooling system
   5.7. A radiator (models with the mechanical transmission)
   5.8. A radiator (models with the automatic transmission)
   5.9. Check and cleaning of a radiator
   5.10. Thermostat
   5.11. Check of operability of the thermostat
   5.12. Water pump
   5.13. Radiator fan
   5.14. Broad tank and sensor of level of cooling liquid
   5.15. Sensor of the index of temperature of cooling liquid
   5.16. Radiator fan thermal sensor
   5.17. Control panel of a heater
   5.18. Heater radiator
   5.19. Heater fan engine
   5.20. Ventilation nozzles
+ 6. Fuel system
+ 7. The fuel and exhaust system of models with system of injection of fuel
+ 8. Exhaust system and system of decrease in toxicity of exhaust gases
+ 9. Fuel systems of the diesel engine
+ 10. Engine electrical systems
+ 11. Transmission
+ 12. Mechanical transmission
+ 13. Automatic transmission
+ 14. Power shafts
+ 15. Brake system
+ 16. Suspension bracket
+ 17. Body
+ 18. Electric equipment
+ 19. Check of malfunctions
24bec775



5.17. Control panel of a heater

Removal

Through an opening for installation of hours unscrew two screws of fastening of the control panel of a heater

Vyvinchivaniye of the right screw of fastening of the control panel of a heater

The managements removed a cable with fixing brackets

PERFORMANCE ORDER
1. Remove a weight wire from the accumulator.
2. Remove decorative finishing of deepening for the passenger's legs, casings of a steering column both the top and lower decorative panels of a combination of devices.
3. Remove from the dashboard hours or the on-board computer.
4. In a niche for hours or the on-board computer unscrew two screws of fastening of the control panel of a heater, then unscrew the remained screw of fastening of the right part of the control panel which is available after removal of the lower finishing of a combination of devices (see rice. Through an opening for ustan ки hours unscrew two screws of fastening of the control panel of a heater, Vyvinchivaniye of the right screw of fastening of the control panel of a heater).
5. From deepening for legs ра disconnect passages from a reverse side of the control panel of a cable heater from control levers. A cable of management fasten plastic brackets, and in certain cases in addition metal brackets which need to be removed before release of a cable from a control lever (see rice. The managements removed a cable with fixing brackets). Mark a cable of management for repeated installation them on the places.
6. Having pulled on itself, remove the control panel of a heater from the dashboard and disconnect from it electric sockets.

Installation

PERFORMANCE ORDER
1. Installation is made in the sequence, the return to removal.
2. In conclusion, moving control levers with a heater from an emphasis against the stop, check work of a heater.