Opel Vectra A

since 1988-1995 release

Repair and operation of the car

Vektr's Opel And
+ 1. Maintenance instruction
+ 1.1 Maintenance
+ 2. Engine
+ 3. Repair of DOHC engines
+ 4. Repair of the diesel engine
- 5. Cooling system
   5.2. General information
   5.3. Antifreeze
   5.4. Washing of the cooling system
   5.5. Discharge of cooling liquid
   5.6. Filling of the cooling system
   5.7. A radiator (models with the mechanical transmission)
   5.8. A radiator (models with the automatic transmission)
   5.9. Check and cleaning of a radiator
   5.10. Thermostat
   5.11. Check of operability of the thermostat
   5.12. Water pump
   5.13. Radiator fan
   5.14. Broad tank and sensor of level of cooling liquid
   5.15. Sensor of the index of temperature of cooling liquid
   5.16. Radiator fan thermal sensor
   5.17. Control panel of a heater
   5.18. Heater radiator
   5.19. Heater fan engine
   5.20. Ventilation nozzles
+ 6. Fuel system
+ 7. The fuel and exhaust system of models with system of injection of fuel
+ 8. Exhaust system and system of decrease in toxicity of exhaust gases
+ 9. Fuel systems of the diesel engine
+ 10. Engine electrical systems
+ 11. Transmission
+ 12. Mechanical transmission
+ 13. Automatic transmission
+ 14. Power shafts
+ 15. Brake system
+ 16. Suspension bracket
+ 17. Body
+ 18. Electric equipment
+ 19. Check of malfunctions


5.13. Radiator fan


Removal of a casing of the fan of a radiator on models of 2,0 l of SOHC

1. Remove a weight wire from the accumulator.
2. Note an arrangement and disconnect the electric socket from the radiator fan engine.
3. Unscrew fastening bolts from two parties in the top part of a casing of the fan of a radiator, then reject a fan casing to the engine, move it up and remove from a radiator (see the drawing).
4. Unscrew three nuts and remove the radiator fan engine from a casing. If necessary remove a spring bracket and remove a krylchatka from a radiator fan engine shaft.
5. If the radiator fan engine is faulty, it is necessary to replace it as repair of the engine is not provided.


1. Installation is made in the sequence, the return to removal. At the same time check that the lower part of a casing of the fan correctly was established on a radiator.
2. In conclusion start the engine, warm up it up to the normal working temperature and check that the fan of a radiator works.