Opel Vectra A

since 1988-1995 release

Repair and operation of the car


Vektr's Opel And
+ 1. Maintenance instruction
+ 1.1 Maintenance
+ 2. Engine
+ 3. Repair of DOHC engines
+ 4. Repair of the diesel engine
- 5. Cooling system
   5.2. General information
   5.3. Antifreeze
   5.4. Washing of the cooling system
   5.5. Discharge of cooling liquid
   5.6. Filling of the cooling system
   5.7. A radiator (models with the mechanical transmission)
   5.8. A radiator (models with the automatic transmission)
   5.9. Check and cleaning of a radiator
   5.10. Thermostat
   5.11. Check of operability of the thermostat
   5.12. Water pump
   5.13. Radiator fan
   5.14. Broad tank and sensor of level of cooling liquid
   5.15. Sensor of the index of temperature of cooling liquid
   5.16. Radiator fan thermal sensor
   5.17. Control panel of a heater
   5.18. Heater radiator
   5.19. Heater fan engine
   5.20. Ventilation nozzles
+ 6. Fuel system
+ 7. The fuel and exhaust system of models with system of injection of fuel
+ 8. Exhaust system and system of decrease in toxicity of exhaust gases
+ 9. Fuel systems of the diesel engine
+ 10. Engine electrical systems
+ 11. Transmission
+ 12. Mechanical transmission
+ 13. Automatic transmission
+ 14. Power shafts
+ 15. Brake system
+ 16. Suspension bracket
+ 17. Body
+ 18. Electric equipment
+ 19. Check of malfunctions


24bec775


5.19. Heater fan engine

Removal

Removal of a casing from the heater fan engine

Unscrewing of screws of fastening of the fan of a heater

Arrangement of a bracket of fastening of an arm of the resistor on the heater fan engine

PERFORMANCE ORDER
1. The engine of the fan of a heater is located under the panel in the lower part of a windshield.
2. Remove the fairing located in the lower part of a windshield.
3. Remove the engine and drafts of a screen wiper.
4. Remove a casing from the top part of the electric motor (see Removal of a casing from the heater fan engine).
5. Disconnect the electric socket from the heater fan engine
Unscrew two screws and take the heater fan from a casing (see rice. Unscrewing of screws of fastening of the fan of a heater).
Squeeze brackets of fastening and remove an arm with the resistor. After ustan ки the new resistor accurately record its brackets of fastening (see rice. An arrangement of a bracket of fastening of an arm of the resistor on the heater fan engine).
If the engine of the fan of a heater failed replace it as its repair is not provided.

Installation

PERFORMANCE ORDER
1. Installation is made in the sequence, the return to removal. Check correctness of an arrangement of a rubber pillow of the engine of the fan of a heater.