Opel Vectra A

since 1988-1995 release

Repair and operation of the car

Vektr's Opel And
+ 1. Maintenance instruction
+ 1.1 Maintenance
+ 2. Engine
+ 3. Repair of DOHC engines
+ 4. Repair of the diesel engine
+ 5. Cooling system
+ 6. Fuel system
+ 7. The fuel and exhaust system of models with system of injection of fuel
+ 8. Exhaust system and system of decrease in toxicity of exhaust gases
+ 9. Fuel systems of the diesel engine
+ 10. Engine electrical systems
+ 11. Transmission
+ 12. Mechanical transmission
- 13. Automatic transmission
   13.2. General information
   13.3. Replacement of transmission liquid
   13.4. Adjustment of the mechanism of compulsory inclusion of a low gear
   13.5. Mechanism of compulsory inclusion of a low gear
   13.6. Switch of blocking of a starter
   13.7. Adjustment of a cable of gear shifting
   13.8. Gear shifting cable
   13.9. Selector lever
   13:10. Central console
   13:11. Submode switches
   13:12. Electronic control device (ECU)
   13:13. Replacement of a lamp of illumination of the panel of the lever of the selector
   13:14. Hoses and tubes of a radiator of cooling of transmission liquid
   13:15. Replacement of sealing rings of differential
   13:16. Sensor of temperature of transmission liquid
   13:17. Sensors of speed of rotation of entrance and output shaft
   13:18. Removal and installation of the automatic transmission
+ 14. Power shafts
+ 15. Brake system
+ 16. Suspension bracket
+ 17. Body
+ 18. Electric equipment
+ 19. Check of malfunctions

13.6. Switch of blocking of a starter

Removal

PERFORMANCE ORDER

1. Tighten the emergency brake and install the selector lever in situation N.

2. Remove a weight wire from the accumulator.

3. Unscrew a nut and remove a pipe for the probe of measurement of level of liquid / a bulk mouth.

4. Release a clamp, remove a washer and disconnect a switching cable from a control lever on the transmission.

5. Disconnect the electric socket from the switch.

6. Flat-nose pliers record a shaft from a provorachivaniye, then unscrew the nut fixing a control lever to a selector lever shaft. Wring out the plate uvula holding a nut from a provorachivaniye and unscrew the big nut with a washer fixing the switch to a shaft. Unscrew a clamp which fixes the switch to the transmission.

Installation

PERFORMANCE ORDER

1. Before installation check that the lever of the choice of transfers is installed in situation N, i.e. the third situation from a forward part. Install the switch on a shaft and screw in it against the stop switch cases in a reinforced surface of a shaft. Then tighten a switch clamp / a bulk mouth the required moment.

2. Being careful, tighten the required moment the big nut fixing the switch to a shaft of the lever of the choice of transfers. Record a nut from unscrewing for what bend a short mustache of the fixing plate.

3. For installation of a control lever the transmission on a shaft of the lever of the choice of transfers by flat-nose pliers hold a shaft from a provorachivaniye and tighten a nut the required moment.

4. Establish a pipe for the probe of measurement of level / a bulk mouth with a new sealing ring which needs to be greased for installation simplification. Tighten a nut of fastening of a pipe the required moment.

5. Connect the electric socket and a cable of gear shifting to the switch, then check and, if necessary, adjust a cable.

home