Opel Vectra A

since 1988-1995 release

Repair and operation of the car


Vektr's Opel And
+ 1. Maintenance instruction
+ 1.1 Maintenance
+ 2. Engine
+ 3. Repair of DOHC engines
+ 4. Repair of the diesel engine
+ 5. Cooling system
+ 6. Fuel system
+ 7. The fuel and exhaust system of models with system of injection of fuel
+ 8. Exhaust system and system of decrease in toxicity of exhaust gases
+ 9. Fuel systems of the diesel engine
+ 10. Engine electrical systems
+ 11. Transmission
+ 12. Mechanical transmission
- 13. Automatic transmission
   13.2. General information
   13.3. Replacement of transmission liquid
   13.4. Adjustment of the mechanism of compulsory inclusion of a low gear
   13.5. Mechanism of compulsory inclusion of a low gear
   13.6. Switch of blocking of a starter
   13.7. Adjustment of a cable of gear shifting
   13.8. Gear shifting cable
   13.9. Selector lever
   13:10. Central console
   13:11. Submode switches
   13:12. Electronic control device (ECU)
   13:13. Replacement of a lamp of illumination of the panel of the lever of the selector
   13:14. Hoses and tubes of a radiator of cooling of transmission liquid
   13:15. Replacement of sealing rings of differential
   13:16. Sensor of temperature of transmission liquid
   13:17. Sensors of speed of rotation of entrance and output shaft
   13:18. Removal and installation of the automatic transmission
+ 14. Power shafts
+ 15. Brake system
+ 16. Suspension bracket
+ 17. Body
+ 18. Electric equipment
+ 19. Check of malfunctions


24bec775


13:12. Electronic control device (ECU)

Removal

Depending on model and year of release the electronic device (ECU) of the automatic transmission settles down or in deepening for legs of the driver or behind a ware box.

PERFORMANCE ORDER
1. Remove a weight wire from the accumulator.
2. For access to the ECU block remove the side panel of finishing in deepening for legs of the driver and the lower panel of finishing of the dashboard. If the ECU block is located behind a ware box, remove a ware box. In this case the block is located from a reverse side of the top part of the dashboard.
3. Take the ECU block from fastenings, then release clamps and disconnect the electric socket from the block.

Installation

PERFORMANCE ORDER
1. Installation is made in the sequence, the return to removal.
2. Check reliability of connection of the electric socket.