Opel Vectra A

since 1988-1995 release

Repair and operation of the car

Vektr's Opel And
+ 1. Maintenance instruction
+ 1.1 Maintenance
+ 2. Engine
+ 3. Repair of DOHC engines
+ 4. Repair of the diesel engine
+ 5. Cooling system
+ 6. Fuel system
+ 7. The fuel and exhaust system of models with system of injection of fuel
+ 8. Exhaust system and system of decrease in toxicity of exhaust gases
+ 9. Fuel systems of the diesel engine
+ 10. Engine electrical systems
+ 11. Transmission
+ 12. Mechanical transmission
- 13. Automatic transmission
   13.2. General information
   13.3. Replacement of transmission liquid
   13.4. Adjustment of the mechanism of compulsory inclusion of a low gear
   13.5. Mechanism of compulsory inclusion of a low gear
   13.6. Switch of blocking of a starter
   13.7. Adjustment of a cable of gear shifting
   13.8. Gear shifting cable
   13.9. Selector lever
   13:10. Central console
   13:11. Submode switches
   13:12. Electronic control device (ECU)
   13:13. Replacement of a lamp of illumination of the panel of the lever of the selector
   13:14. Hoses and tubes of a radiator of cooling of transmission liquid
   13:15. Replacement of sealing rings of differential
   13:16. Sensor of temperature of transmission liquid
   13:17. Sensors of speed of rotation of entrance and output shaft
   13:18. Removal and installation of the automatic transmission
+ 14. Power shafts
+ 15. Brake system
+ 16. Suspension bracket
+ 17. Body
+ 18. Electric equipment
+ 19. Check of malfunctions

24bec775 Смотри здесь феминизированные Семена марихуаны.
Video adult chat room.

13:17. Sensors of speed of rotation of entrance and output shaft


1. Sensors are installed in the top part of a case of the transmission. Sensors can be identified on an arrangement of electric sockets. The electric socket of the sensor of speed of rotation of an entrance shaft is located on the left side of the transmission.
2. Remove a weight wire from the accumulator.
3. Disconnect the electric socket of the sensor.
4. Unscrew the screw of fastening of the sensor and then unscrew the sensor. Close an opening for the sensor a suitable stopper.


Installation is made in the sequence, the return to removal. At installation of the sensor it is necessary to use a new sealing ring. Tighten the screw of fastening of the sensor the required moment.