Opel Vectra A

since 1988-1995 release

Repair and operation of the car



Vektr's Opel And
+ 1. Maintenance instruction
+ 1.1 Maintenance
+ 2. Engine
+ 3. Repair of DOHC engines
+ 4. Repair of the diesel engine
+ 5. Cooling system
+ 6. Fuel system
+ 7. The fuel and exhaust system of models with system of injection of fuel
+ 8. Exhaust system and system of decrease in toxicity of exhaust gases
+ 9. Fuel systems of the diesel engine
+ 10. Engine electrical systems
+ 11. Transmission
+ 12. Mechanical transmission
- 13. Automatic transmission
   13.2. General information
   13.3. Replacement of transmission liquid
   13.4. Adjustment of the mechanism of compulsory inclusion of a low gear
   13.5. Mechanism of compulsory inclusion of a low gear
   13.6. Switch of blocking of a starter
   13.7. Adjustment of a cable of gear shifting
   13.8. Gear shifting cable
   13.9. Selector lever
   13:10. Central console
   13:11. Submode switches
   13:12. Electronic control device (ECU)
   13:13. Replacement of a lamp of illumination of the panel of the lever of the selector
   13:14. Hoses and tubes of a radiator of cooling of transmission liquid
   13:15. Replacement of sealing rings of differential
   13:16. Sensor of temperature of transmission liquid
   13:17. Sensors of speed of rotation of entrance and output shaft
   13:18. Removal and installation of the automatic transmission
+ 14. Power shafts
+ 15. Brake system
+ 16. Suspension bracket
+ 17. Body
+ 18. Electric equipment
+ 19. Check of malfunctions



13.4. Adjustment of the mechanism of compulsory inclusion of a low gear

PERFORMANCE ORDER
1. If necessary for access to a butterfly valve remove the heater block, the air filter and a tube of an air inlet.
2. The assistant has to press an accelerator pedal so that it moved to the switch fixed on a car floor. In this provision of a pedal check that the butterfly valve completely opened, and the central part of a pedal presses the switch button.
3. For adjustment weaken the persistent screw of a pedal of an accelerator and adjust accelerator cable length. If necessary, adjust an accelerator cable so that the side play of a pedal was minimum.
4. If the pedal does not press the switch button, check a condition of an axis of a pedal and raise the switch from the holder or bend a pedal.