Opel Vectra A

since 1988-1995 release

Repair and operation of the car



Vektr's Opel And
+ 1. Maintenance instruction
+ 1.1 Maintenance
+ 2. Engine
+ 3. Repair of DOHC engines
+ 4. Repair of the diesel engine
+ 5. Cooling system
+ 6. Fuel system
+ 7. The fuel and exhaust system of models with system of injection of fuel
+ 8. Exhaust system and system of decrease in toxicity of exhaust gases
+ 9. Fuel systems of the diesel engine
+ 10. Engine electrical systems
+ 11. Transmission
+ 12. Mechanical transmission
- 13. Automatic transmission
   13.2. General information
   13.3. Replacement of transmission liquid
   13.4. Adjustment of the mechanism of compulsory inclusion of a low gear
   13.5. Mechanism of compulsory inclusion of a low gear
   13.6. Switch of blocking of a starter
   13.7. Adjustment of a cable of gear shifting
   13.8. Gear shifting cable
   13.9. Selector lever
   13:10. Central console
   13:11. Submode switches
   13:12. Electronic control device (ECU)
   13:13. Replacement of a lamp of illumination of the panel of the lever of the selector
   13:14. Hoses and tubes of a radiator of cooling of transmission liquid
   13:15. Replacement of sealing rings of differential
   13:16. Sensor of temperature of transmission liquid
   13:17. Sensors of speed of rotation of entrance and output shaft
   13:18. Removal and installation of the automatic transmission
+ 14. Power shafts
+ 15. Brake system
+ 16. Suspension bracket
+ 17. Body
+ 18. Electric equipment
+ 19. Check of malfunctions


24bec775


13.3. Replacement of transmission liquid

PERFORMANCE ORDER
1. Before replacement of transmission liquid make a small control trip for warming up of the transmission up to the normal working temperature.
2. Install the car on the flat horizontal platform, switch off ignition and tighten the emergency brake. For improvement of access to the transmission lift a forward part of the car and record on supports.
3. Take the probe for measurement of level of liquid in the automatic transmission, then install a container under the drain stopper located in a back right part of the transmission under a power shaft, and unscrew a stopper.
4. Merge liquid from the transmission in a container.
5. After discharge of liquid from the transmission clear a carving on a drain stopper and in a transmission case opening. Establish a new sealing washer on a masloslivny stopper and screw in a stopper in a case of the transmission and tighten it the required moment. Lower the car on the earth.
6. Fill in the required quantity of transmission of this liquid in the automatic transmission, then check liquid level.
7. Start the engine in the idling mode for several minutes. Switch off the engine and check the level of transmission liquid in the transmission. If necessary add liquid. Make control check and repeatedly check the level of transmission liquid.