Opel Vectra A

since 1988-1995 release

Repair and operation of the car



Vektr's Opel And
+ 1. Maintenance instruction
+ 1.1 Maintenance
+ 2. Engine
+ 3. Repair of DOHC engines
+ 4. Repair of the diesel engine
+ 5. Cooling system
+ 6. Fuel system
+ 7. The fuel and exhaust system of models with system of injection of fuel
+ 8. Exhaust system and system of decrease in toxicity of exhaust gases
+ 9. Fuel systems of the diesel engine
+ 10. Engine electrical systems
+ 11. Transmission
+ 12. Mechanical transmission
+ 13. Automatic transmission
+ 14. Power shafts
+ 15. Brake system
+ 16. Suspension bracket
+ 17. Body
- 18. Electric equipment
   18.2. General information
   18.3. Electric chains
   18.4. Detection of a faulty chain
   18.5. Safety locks and relay
   18.6. Ignition lock
   18.7. Switch of lighting and indexes of turns
   18.8. Windscreen washer/screen wiper switch
   18.9. Switches on the dashboard
   18:10. Switch of adjustment of provision of an external mirror
   18:11. Switch of the electric drive of the hatch
   18:12. The switch of illumination of salon installed in a door rack
   18:13. Switch of lighting of the luggage compartment
   18:14. Stoplight switch.
   18:15. Switch of a control lamp of the emergency brake
   18:16. Oil pressure sensor
   18:17. Lighter illumination
   18:18. Hours
   18:19. A front seat with heating
   18:20. Combination of devices
   18:21. Elements of a combination of devices
   18:22. Elements of the on-board computer
   18:23. Elements of a control and management system
   18:24. Sound signal
   18:25. Lamp of illumination of salon
   18:26. Replacement of bulbs of internal lighting
   18:27. Headlight
   18:28. Engine of the proofreader of light of headlights
   18:29. Adjustment of light of headlights
   18:30. System of reduction of intensity of light of headlights
   18:31. Forward index of turns
   18:32. Side repeater of turns
   18:33. Forward fog light
   18:34. Back lamps
   18:35. Lamp of illumination of registration plate
   + 18:36. Replacement of bulbs of external lighting
   18:37. Replacement of brushes of a screen wiper
   18:38. Screen wiper levers
   18:39. Washer jets
   18:40. Engine and drafts of a screen wiper
   18:41. Engine of a screen wiper of a back door
   18:42. Headlight screen wiper engine
   18:43. Windscreen washer tank
   18:44. Windscreen washer pump
   18:45. Unidirectional valve of a washer of headlights
   18:46. Elements of window regulators with the electric drive
   18:47. Programming of a control system of window regulators
   18:48. Elements of the central blocking of doors
   18:49. Antenna
   18:50. An antenna mast with the electric drive
   18:51. Loudspeakers
   18:52. Radio tape recorder
   18:53. Hatch drive electric motor
   18:54. Speedometer drive cable
   18:55. Anticreeping alarm system
   18:56. Elements of the anticreeping alarm system
   18:57. Safety cushion
   18:58. A safety cushion from the driver
   18:59. A steering wheel with a safety cushion
   18.60. Contact block of a safety cushion
   18.61. A safety cushion from the passenger
   18.62. A safety cushion arm from the passenger
   18.63. Control unit of safety cushions
   + 18.64. Electric circuits
+ 19. Check of malfunctions


24bec775


18:48. Elements of the central blocking of doors

GENERAL INFORMATION

Remove a weight wire from the accumulator.

CONTROL UNIT

Removal

Unscrewing of a nut of fastening of the control unit of the central blocking of doors

PERFORMANCE ORDER
1. The control unit is located in deepening for the driver's legs.
2. Remove the finishing panel in deepening for the driver's legs.
3. Unscrew two nuts and remove the control unit (see rice. Unscrewing of a nut of fastening of the control unit of the central blocking of doors).
4. Release a clamp of the socket and disconnect the electric socket from the control unit.

Installation

PERFORMANCE ORDER
1. Installation is made in the sequence, the return to removal.

SWITCH

Removal

Arrangement of the microswitch of the central blocking of doors

PERFORMANCE ORDER
1. The switch represents the microswitch which is located at doors in a back part of the external handle.
2. Remove a door upholstery.
3. Remove a protective film for access to the external handle of opening of a door.
4. Disconnect the microswitch from a back part of the external handle of opening of a door and disconnect the electric socket of wires of the microswitch from a plait of wires of a door, then take микровыклю a chatel from a door (see rice. Arrangement of the microswitch of the central blocking of doors).

Installation

PERFORMANCE ORDER
1. Installation is made in the sequence, the return to removal.

ELECTRIC MOTOR, MANAGING DIRECTOR OF THE DOOR LOCK

Removal

PERFORMANCE ORDER
1. Remove the door lock.
2. Disconnect draft of the lock from an elektrodva of a gatel.
3. Unscrew two screws and remove the electric motor from the door lock.

Installation

PERFORMANCE ORDER
1. Installation is made in the sequence, the return to removal.

ELECTRIC MOTOR OF THE LOCK OF THE BACK DOOR / LUGGAGE CARRIER

Removal

Detachment of the electric socket from the electric motor of the lock of a back door on the Hatchback model

PERFORMANCE ORDER
1. On the Hatchback models unscrew screws and remove an upholstery of a back door.
2. Unscrew two screws and, moving the electric motor, disconnect draft of the lock.
3. Take the electric motor and disconnect from it the electric socket (see rice. A detachment of the electric socket from the electric motor of the lock of a back door on the Hatchback model).

Installation

PERFORMANCE ORDER
1. Installation is made in the sequence, the return to removal.

ELECTRIC MOTOR OF THE LOCK OF THE FOLDING SHUTTER OF THE TOPLIVNOZALIVNY MOUTH OF THE FUEL TANK

Removal

Detachment of the electric socket from the electric motor of the lock of a folding shutter of a toplivon of a livny mouth of the fuel tank on the Hatchback models

PERFORMANCE ORDER
1. Remove the right back panel of finishing of the luggage compartment.
2. Disconnect the electric socket from a back part of the electric motor (see rice. A detachment of the electric socket from the electric motor of the lock of a folding shutter of a toplivon of a livny mouth of the fuel tank on the Hatchback models).
3. Unscrew two screws fixing the electric motor to an arm then, moving the electric motor, disconnect draft of the lock. Take the electric motor.

Installation

PERFORMANCE ORDER
1. Installation is made in the sequence, the return to removal.