Vektr's Opel And + 1. Maintenance instruction + 1.1 Maintenance + 2. Engine - 3. Repair of DOHC engines 3.2. General information 3.3. Removal and installation of the engine 3.4. Replacement of support of the power unit + 3.5. Gear belt, pulleys, pulley of the mechanism of a tension and intermediate pulley 3.6. A gear belt with the automatic mechanism of a tension 3.7. Forward sealing ring of the camshaft 3.8. Camshafts 3.9. Installation of a head of the block of cylinders on the engine installed in the car 3.10. Installation of a head of the block of cylinders on the engine removed from the car 3.11. Repair of a head of the block of cylinders 3.12. Hydraulic pushers of valves 3.13. Replacement of a forward sealing ring of a bent shaft 3.14. Oil pallet 3.15. Oil pump 3.16. Oil heater + 4. Repair of the diesel engine + 5. Cooling system + 6. Fuel system + 7. The fuel and exhaust system of models with system of injection of fuel + 8. Exhaust system and system of decrease in toxicity of exhaust gases + 9. Fuel systems of the diesel engine + 10. Engine electrical systems + 11. Transmission + 12. Mechanical transmission + 13. Automatic transmission + 14. Power shafts + 15. Brake system + 16. Suspension bracket + 17. Body + 18. Electric equipment + 19. Check of malfunctions
|
Places of connection of tubes of the oil heater to the oil pump
Arrangement of bolts of fastening of the oil pump (arrow) and arrangement of an intermediate ring of a bent shaft (A)
Removal Removal of the oil pump is made in the same way, as well as on the SOHC engine (see subsection 2.28).
Installation Installation of the oil pump is made in the same way, as well as on SOHC engines (see subsection 2.28).
PERFORMANCE ORDER |
1. Apply a thin film of sealant on the interfaced surface of the oil pump with an intermediate ring, then establish an intermediate ring on a bent shaft to a contact of its oil pump. |
2. Establish a new gear belt. |
3. Connect the pipes going from the oil heater to the oil pump. |
|
|
|