Opel Vectra A

since 1988-1995 release

Repair and operation of the car

Vektr's Opel And
+ 1. Maintenance instruction
+ 1.1 Maintenance
+ 2. Engine
+ 3. Repair of DOHC engines
+ 4. Repair of the diesel engine
+ 5. Cooling system
+ 6. Fuel system
+ 7. The fuel and exhaust system of models with system of injection of fuel
+ 8. Exhaust system and system of decrease in toxicity of exhaust gases
+ 9. Fuel systems of the diesel engine
+ 10. Engine electrical systems
+ 11. Transmission
- 12. Mechanical transmission
   12.2. General information
   12.3. Adjustment of draft of the mechanism of the choice of transfers
   12.4. Gear shifting lever knot
   12.5. Draft of the mechanism of the choice of transfers
   12.6. Gear shifting lever
   12.7. Protective cover of the lever of gear shifting
   12.8. Sealing rings of differential
   12.9. Sealing ring of an entrance shaft of the transmission
   12:10. Removal and installation of the transmission
   12:11. Repair of the transmission
   12:12. Speedometer drive
   12:13. Switch of lamps of a backing
+ 13. Automatic transmission
+ 14. Power shafts
+ 15. Brake system
+ 16. Suspension bracket
+ 17. Body
+ 18. Electric equipment
+ 19. Check of malfunctions

12.9. Sealing ring of an entrance shaft of the transmission

GENERAL INFORMATION

Prevention

At installation it is necessary to use a new sealing ring of the directing plug of the release bearing.

Removal

PERFORMANCE ORDER

1. Remove the release bearing and a fork of switching off of coupling.

2. Unscrew bolts and remove a guide of the plug of the release bearing from a coupling case. Remove a sealant of Nov the ring located between the directing plug and a case of coupling.

3. Using a screw-driver edge as the lever, remove a sealing ring from the directing plug of the release bearing.

Installation

PERFORMANCE ORDER

1. Using a tubular mandrel of the corresponding diameter, install a new sealing ring in the directing plug.

2. Fill space between working edges of a new sealing ring lithium lubricant, then install the directing plug with a new sealing ring, without using lubricant.

3. Install the release bearing and a fork of switching off of coupling.

home

QX4.ONLINE
S40.ONLINE
A-8.ONLINE
W124.ONLINE
RX300.ONLINE
W140.ONLINE
B3-B4.SPACE
B3B4.SPACE
A-8.SPACE