Opel Vectra A

since 1988-1995 release

Repair and operation of the car



Vektr's Opel And
+ 1. Maintenance instruction
+ 1.1 Maintenance
+ 2. Engine
+ 3. Repair of DOHC engines
+ 4. Repair of the diesel engine
+ 5. Cooling system
+ 6. Fuel system
+ 7. The fuel and exhaust system of models with system of injection of fuel
+ 8. Exhaust system and system of decrease in toxicity of exhaust gases
+ 9. Fuel systems of the diesel engine
+ 10. Engine electrical systems
+ 11. Transmission
- 12. Mechanical transmission
   12.2. General information
   12.3. Adjustment of draft of the mechanism of the choice of transfers
   12.4. Gear shifting lever knot
   12.5. Draft of the mechanism of the choice of transfers
   12.6. Gear shifting lever
   12.7. Protective cover of the lever of gear shifting
   12.8. Sealing rings of differential
   12.9. Sealing ring of an entrance shaft of the transmission
   12:10. Removal and installation of the transmission
   12:11. Repair of the transmission
   12:12. Speedometer drive
   12:13. Switch of lamps of a backing
+ 13. Automatic transmission
+ 14. Power shafts
+ 15. Brake system
+ 16. Suspension bracket
+ 17. Body
+ 18. Electric equipment
+ 19. Check of malfunctions


24bec775


12.4. Gear shifting lever knot

Removal

PERFORMANCE ORDER
1. In a motor compartment weaken tightening a bolt, the fixing rod of the mechanism of the choice of transfer to draft.
2. Remove the gear shifting lever.
3. Remove a forward part of the central console.
4. Unscrew four bolts fixing gear shifting lever knot to the car bottom.
5. Move knot of the lever of the choice of transfers together with a rod to a back part of the car and take a rod through a partition, at the same time the assistant has to remove from the end of a rod a clip not to damage rubber consolidation in a partition.
6. If necessary replace rubber consolidation in a partition.

Installation

PERFORMANCE ORDER
1. For replacement of the plug of a rod of the mechanism of the choice of transfers move a rod from gear shifting lever knot. Using a screw-driver edge as the lever, remove assembly of the plug from gear shifting lever knot, then take the plug from a casing. You make assembly in the sequence, the return dismantling, at the same time grease with silicone lubricant the internal surface of the plug.
2. Installation is made in the sequence, the return to removal, but before tightening tightening a bolt of a rod of the mechanism of the choice of transfers, adjust draft of the mechanism of the choice of transfers.