Opel Vectra A

since 1988-1995 release

Repair and operation of the car



Vektr's Opel And
+ 1. Maintenance instruction
+ 1.1 Maintenance
+ 2. Engine
+ 3. Repair of DOHC engines
+ 4. Repair of the diesel engine
+ 5. Cooling system
+ 6. Fuel system
+ 7. The fuel and exhaust system of models with system of injection of fuel
+ 8. Exhaust system and system of decrease in toxicity of exhaust gases
- 9. Fuel systems of the diesel engine
   9.2. General information
   9.3. Case of the air filter
   9.4. Accelerator pedal
   9.5. Fuel level sensor
   9.6. Fuel tank
   9.7. Heater of the fuel filter
   9.8. Discharge of water from the fuel filter
   9.9. Filling and pumping of fuel system
   9.10. Check and adjustment of the maximum turns
   9.11. Check and adjustment of turns of idling
   9.12. Electromagnetic valve of a stop of the engine
   9.13. Fuel pump of high pressure
   9.14. Check and adjustment of the moment of injection of fuel
   9.15. Fuel nozzles
   9.16. Turbocharger
   9.17. Heat exchanger
   9.18. Inlet collector
   9.19. Final collector
+ 10. Engine electrical systems
+ 11. Transmission
+ 12. Mechanical transmission
+ 13. Automatic transmission
+ 14. Power shafts
+ 15. Brake system
+ 16. Suspension bracket
+ 17. Body
+ 18. Electric equipment
+ 19. Check of malfunctions


24bec775


9.4. Accelerator pedal

Removal

Arrangement of a lock ring of an axis of a pedal of an accelerator

PERFORMANCE ORDER
1. In interior of the car remove the lower panel of finishing in deepening for the driver's legs.
2. Remove an accelerator cable cover from an arm in the top part of a pedal and disconnect an accelerator cable from a pedal.
3. On the right side of an axis of a pedal remove a lock ring, then take an axis on the left side of an arm (see the drawing). Remove plugs of an axis of a pedal and a returnable spring of a pedal.
4. Check a condition of plugs of an axis of a pedal of an accelerator and with wear replace them.

Installation

PERFORMANCE ORDER
1. Installation is made in the sequence, the return to removal.
2. In conclusion check work of a butterfly valve, and also, if necessary, adjust an accelerator cable.