Opel Vectra A

since 1988-1995 release

Repair and operation of the car



Vektr's Opel And
+ 1. Maintenance instruction
+ 1.1 Maintenance
+ 2. Engine
+ 3. Repair of DOHC engines
+ 4. Repair of the diesel engine
+ 5. Cooling system
+ 6. Fuel system
+ 7. The fuel and exhaust system of models with system of injection of fuel
+ 8. Exhaust system and system of decrease in toxicity of exhaust gases
- 9. Fuel systems of the diesel engine
   9.2. General information
   9.3. Case of the air filter
   9.4. Accelerator pedal
   9.5. Fuel level sensor
   9.6. Fuel tank
   9.7. Heater of the fuel filter
   9.8. Discharge of water from the fuel filter
   9.9. Filling and pumping of fuel system
   9.10. Check and adjustment of the maximum turns
   9.11. Check and adjustment of turns of idling
   9.12. Electromagnetic valve of a stop of the engine
   9.13. Fuel pump of high pressure
   9.14. Check and adjustment of the moment of injection of fuel
   9.15. Fuel nozzles
   9.16. Turbocharger
   9.17. Heat exchanger
   9.18. Inlet collector
   9.19. Final collector
+ 10. Engine electrical systems
+ 11. Transmission
+ 12. Mechanical transmission
+ 13. Automatic transmission
+ 14. Power shafts
+ 15. Brake system
+ 16. Suspension bracket
+ 17. Body
+ 18. Electric equipment
+ 19. Check of malfunctions


24bec775


9.12. Electromagnetic valve of a stop of the engine

GENERAL INFORMATION

The only electric knot in system of injection is an electromagnetic valve of a stop of the engine which is located on the top part of the fuel pump of high pressure. If the electromagnetic valve of a stop of the engine or a chain of its food is faulty, the engine cannot be started as supply of fuel to fuel nozzles will be blocked.

Arrangement of the feeding wire of the electromagnetic valve of a stop of the engine

Electromagnetic valve of a stop of the engine, sealing ring, spring and plunger

PERFORMANCE ORDER
1. Remove an inlet collector.
2. Remove a rubber cover from the top part the valve, unscrew a nut and remove the feeding wire (see rice. Arrangement of the feeding wire of the electromagnetic valve of a stop of the engine).
3. Unscrew the electromagnetic valve and take a plunger and a spring from the fuel pump (see rice. Electromagnetic valve of a stop of the engine, sealing ring, spring and plunger).
4. Installation is made in the sequence, the return to removal.