Opel Vectra A

since 1988-1995 release

Repair and operation of the car



Vektr's Opel And
+ 1. Maintenance instruction
+ 1.1 Maintenance
+ 2. Engine
+ 3. Repair of DOHC engines
+ 4. Repair of the diesel engine
+ 5. Cooling system
+ 6. Fuel system
+ 7. The fuel and exhaust system of models with system of injection of fuel
+ 8. Exhaust system and system of decrease in toxicity of exhaust gases
+ 9. Fuel systems of the diesel engine
+ 10. Engine electrical systems
- 11. Transmission
   11.2. General information
   11.3. Coupling cable
   11.4. Adjustment of a cable of coupling
   11.5. Coupling pedal
   - 11.6. Couplings (the engine and the transmission are installed in the car)
      11.6.2. Check
      11.6.3. Installation
   11.7. Coupling (the transmission is removed)
   11.8. Release bearing
+ 12. Mechanical transmission
+ 13. Automatic transmission
+ 14. Power shafts
+ 15. Brake system
+ 16. Suspension bracket
+ 17. Body
+ 18. Electric equipment
+ 19. Check of malfunctions


24bec775


11.6.2. Check

PERFORMANCE ORDER
1. Check overlays of a clutch plate for wear, mechanical damages or pollution by oil.
2. With these defects the clutch plate needs to be replaced.
3. If frictional slips in good shape are also not worn-out to grooves, springs of a damper are reliably fixed and rivet connections are not loosened, then the clutch plate can be installed in the car.
4. If the clutch plate is polluted by oil, check the left oil sealing ring of a bent shaft or a main shaft of the transmission. If necessary replace sealing rings before installation of a new clutch plate.
5. Check knot of a drive plate for wear of a press disk, mechanical damages, reliability of rivet connection, damage of a diaphragm spring of coupling. If the spring of a diaphragm is worn-out or damaged, or there are suspicions that elasticity of a spring changed, then it is necessary to replace knot of a drive plate.
6. Check the working surfaces of a press disk and a flywheel interfaced to overlays of a clutch plate. They have to be pure, flat and not have scratches and development.
7. Check press the bearing which has to rotate easily, evenly and silently. The working surface of the bearing influencing a press spring has to be smooth, without cracks, local corrosion or development.