Opel Vectra A

since 1988-1995 release

Repair and operation of the car

Vektr's Opel And
+ 1. Maintenance instruction
+ 1.1 Maintenance
+ 2. Engine
+ 3. Repair of DOHC engines
+ 4. Repair of the diesel engine
+ 5. Cooling system
+ 6. Fuel system
+ 7. The fuel and exhaust system of models with system of injection of fuel
+ 8. Exhaust system and system of decrease in toxicity of exhaust gases
+ 9. Fuel systems of the diesel engine
+ 10. Engine electrical systems
- 11. Transmission
   11.2. General information
   11.3. Coupling cable
   11.4. Adjustment of a cable of coupling
   11.5. Coupling pedal
   + 11.6. Couplings (the engine and the transmission are installed in the car)
   11.7. Coupling (the transmission is removed)
   11.8. Release bearing
+ 12. Mechanical transmission
+ 13. Automatic transmission
+ 14. Power shafts
+ 15. Brake system
+ 16. Suspension bracket
+ 17. Body
+ 18. Electric equipment
+ 19. Check of malfunctions

11.5. Coupling pedal

Removal

Arrangement of a bracket of fixing of an axis of a pedal of coupling

The elements of a pedal of coupling located as if the pedal of coupling would be in the car

And – the place of fastening of a cable of coupling by a returnable spring

Elements of an axis of fastening of a pedal of coupling

PERFORMANCE ORDER

1. Measure length of a carving tip of a cable of coupling acting from the squeezing lever in a motor compartment. This size needs to be used for ensuring the correct installation of a cable of coupling.

2. Remove the bracket fixing a carving tip of a cable of coupling to the squeezing lever and remove a carving tip from the lever. For simplification of removal move the lever to the engine.

3. In interior of the car remove the lower panel of finishing in deepening for the driver's legs.

4. On the right side of an axis of a pedal of coupling remove the fixing bracket, then unscrew a nut of fastening of a pedal and remove a washer (see rice. Arrangement of a bracket of fixing of an axis of a pedal of coupling).

5. Take a coupling pedal axis from an arm, then lower a pedal and a returnable spring down. Note an arrangement of washers and laying on a coupling pedal axis for their repeated installation on the places.

6. Disconnect a coupling cable from a coupling pedal, release a returnable spring and take a pedal of coupling and a returnable spring from the car (see rice. The elements of a pedal of coupling located as if the pedal of coupling would be in the car, Elements of an axis of fastening of a pedal of coupling).

Installation

PERFORMANCE ORDER

1. Installation is made in the sequence, the return to removal. Before installation grease an axis of a pedal of coupling with lubricant on the basis of a molybdenum disulfide.

2. If necessary adjust a coupling cable.