Vektr's Opel And
+ 1. Maintenance instruction
+ 1.1 Maintenance
+ 2. Engine
+ 3. Repair of DOHC engines
+ 4. Repair of the diesel engine
+ 5. Cooling system
+ 6. Fuel system
+ 7. The fuel and exhaust system of models with system of injection of fuel
+ 8. Exhaust system and system of decrease in toxicity of exhaust gases
+ 9. Fuel systems of the diesel engine
+ 10. Engine electrical systems
+ 11. Transmission
+ 12. Mechanical transmission
+ 13. Automatic transmission
+ 14. Power shafts
+ 15. Brake system
+ 16. Suspension bracket
+ 17. Body
- 18. Electric equipment
18.2. General information
18.3. Electric chains
18.4. Detection of a faulty chain
18.5. Safety locks and relay
18.6. Ignition lock
18.7. Switch of lighting and indexes of turns
18.8. Windscreen washer/screen wiper switch
18.9. Switches on the dashboard
18:10. Switch of adjustment of provision of an external mirror
18:11. Switch of the electric drive of the hatch
18:12. The switch of illumination of salon installed in a door rack
18:13. Switch of lighting of the luggage compartment
18:14. Stoplight switch.
18:15. Switch of a control lamp of the emergency brake
18:16. Oil pressure sensor
18:17. Lighter illumination
18:18. Hours
18:19. A front seat with heating
18:20. Combination of devices
18:21. Elements of a combination of devices
18:22. Elements of the on-board computer
18:23. Elements of a control and management system
18:24. Sound signal
18:25. Lamp of illumination of salon
18:26. Replacement of bulbs of internal lighting
18:27. Headlight
18:28. Engine of the proofreader of light of headlights
18:29. Adjustment of light of headlights
18:30. System of reduction of intensity of light of headlights
18:31. Forward index of turns
18:32. Side repeater of turns
18:33. Forward fog light
18:34. Back lamps
18:35. Lamp of illumination of registration plate
+ 18:36. Replacement of bulbs of external lighting
18:37. Replacement of brushes of a screen wiper
18:38. Screen wiper levers
18:39. Washer jets
18:40. Engine and drafts of a screen wiper
18:41. Engine of a screen wiper of a back door
18:42. Headlight screen wiper engine
18:43. Windscreen washer tank
18:44. Windscreen washer pump
18:45. Unidirectional valve of a washer of headlights
18:46. Elements of window regulators with the electric drive
18:47. Programming of a control system of window regulators
18:48. Elements of the central blocking of doors
18:49. Antenna
18:50. An antenna mast with the electric drive
18:51. Loudspeakers
18:52. Radio tape recorder
18:53. Hatch drive electric motor
18:54. Speedometer drive cable
18:55. Anticreeping alarm system
18:56. Elements of the anticreeping alarm system
18:57. Safety cushion
18:58. A safety cushion from the driver
18:59. A steering wheel with a safety cushion
18.60. Contact block of a safety cushion
18.61. A safety cushion from the passenger
18.62. A safety cushion arm from the passenger
18.63. Control unit of safety cushions
+ 18.64. Electric circuits
+ 19. Check of malfunctions
|
| PERFORMANCE ORDER |
| 1. Remove a weight wire from the accumulator. |
|
DISPLAY MODULE Removal
| PERFORMANCE ORDER |
| 1. Using an edge of the thin screw-driver as the lever, being careful, remove the module from the dashboard. |
| 2. Disconnect the electric socket from the display module. |
|
Installation
| PERFORMANCE ORDER |
| 1. Installation is made in the sequence, the return to removal. |
|
DISPLAY MODULE LIGHTING LAMP
Removal
Extraction of the lighting lamp of the display of the on-board computer
Installation
| PERFORMANCE ORDER |
| 1. Installation is made in the sequence, the return to removal. |
|
SWITCH OF MANAGEMENT
Removal
| PERFORMANCE ORDER |
| 1. Remove a back part of the central console. |
| 2. Using the screw-driver, disconnect the electric socket from the switch. |
| 3. Lift the switch, then move it down and take from the central console. |
|
Installation
| PERFORMANCE ORDER |
| 1. Installation is made in the sequence, the return to removal. |
|
SENSOR OF TEMPERATURE OF EXTERNAL AIR
Removal
Arrangement of the sensor of temperature of external air
| PERFORMANCE ORDER |
| 1. The sensor is located on the left side on a front bumper (see rice. Arrangement of the sensor of temperature of external air). |
| 2. Using a screw-driver edge as the lever, remove a protective cover of the sensor from a bumper, then remove the sensor and disconnect from it the electric socket. |
|
Installation
| PERFORMANCE ORDER |
| 1. Installation is made in the sequence, the return to removal. |
|
|
|
