Opel Vectra A

since 1988-1995 release

Repair and operation of the car

Vektr's Opel And
+ 1. Maintenance instruction
+ 1.1 Maintenance
+ 2. Engine
+ 3. Repair of DOHC engines
+ 4. Repair of the diesel engine
+ 5. Cooling system
+ 6. Fuel system
+ 7. The fuel and exhaust system of models with system of injection of fuel
+ 8. Exhaust system and system of decrease in toxicity of exhaust gases
+ 9. Fuel systems of the diesel engine
+ 10. Engine electrical systems
- 11. Transmission
   11.2. General information
   11.3. Coupling cable
   11.4. Adjustment of a cable of coupling
   11.5. Coupling pedal
   + 11.6. Couplings (the engine and the transmission are installed in the car)
   11.7. Coupling (the transmission is removed)
   11.8. Release bearing
+ 12. Mechanical transmission
+ 13. Automatic transmission
+ 14. Power shafts
+ 15. Brake system
+ 16. Suspension bracket
+ 17. Body
+ 18. Electric equipment
+ 19. Check of malfunctions

TRANSMISSION

11. Coupling

11.1. Technical characteristic

Type	One-disk, with the hummock drive
Diameter of a clutch plate:
– 14 NV	190 mm
– X16 SV, C16 NZ, C16 NZ2 and 18 SV	200 mm
– C18 NZ, 20 NE, C20 NE and 20 SEN	216 mm
– 20 XEJ, C20 XE and X20 XEV	228 mm
Coupling pedal course:
– all models	134,0 – 141,0 mm

Tightening moments

Protective plate of a case of coupling:
– stamped	12 Nanometer
– cast	6 Nanometer
The leading part of coupling to a flywheel	15 Nanometer
Fork of switching off of coupling to an axis of the squeezing lever	35 Nanometer
Bolt in an end face of an entrance shaft	15 Nanometer
Guide of the release bearing to a transmission case	5 Nanometer
Cover in a transmission end face:
– M7 bolts	15 Nanometer
– M8 bolts	20 Nanometer

home