Opel Vectra A

since 1988-1995 release

Repair and operation of the car



Vektr's Opel And
+ 1. Maintenance instruction
+ 1.1 Maintenance
+ 2. Engine
+ 3. Repair of DOHC engines
+ 4. Repair of the diesel engine
+ 5. Cooling system
+ 6. Fuel system
+ 7. The fuel and exhaust system of models with system of injection of fuel
+ 8. Exhaust system and system of decrease in toxicity of exhaust gases
+ 9. Fuel systems of the diesel engine
+ 10. Engine electrical systems
+ 11. Transmission
- 12. Mechanical transmission
   12.2. General information
   12.3. Adjustment of draft of the mechanism of the choice of transfers
   12.4. Gear shifting lever knot
   12.5. Draft of the mechanism of the choice of transfers
   12.6. Gear shifting lever
   12.7. Protective cover of the lever of gear shifting
   12.8. Sealing rings of differential
   12.9. Sealing ring of an entrance shaft of the transmission
   12:10. Removal and installation of the transmission
   12:11. Repair of the transmission
   12:12. Speedometer drive
   12:13. Switch of lamps of a backing
+ 13. Automatic transmission
+ 14. Power shafts
+ 15. Brake system
+ 16. Suspension bracket
+ 17. Body
+ 18. Electric equipment
+ 19. Check of malfunctions


24bec775


12. Mechanical transmission

12.1. Technical characteristic

Type
5 synchronized transfers of the forward course and 1 transfer of a backing
Type
Code
With big (WR) or small (CR) transfer ratio
– 14 NV
F10
WR
– 16 SV, C16 NZ, C16 NZ2 and X16 SZ
F13
WR
– 18 SV, C18 NZ, 20 NE, C20 NE and 20 SEH:
   • till 1994
F16
WR or CR
   • since 1994
F18
WR or CR
– 20 XEJ
F20
CR
– C20 XE:
   • till 1994
F20
CR
   • since 1994
F18 +
CR
– X20 XEV
F18
WR or CR

Tightening moments

Fork of inclusion of the 5th transfer to an intermediate plate
22 Nanometer
Latch of a clamp of the 5th transfer to an intermediate plate
7 Nanometer
Protective plate of a case of coupling
7 Nanometer
Differential cover to the transmission:
– cast
18 Nanometer
– stamped
30 Nanometer
Face cover to the transmission:
– M7 bolts
15 Nanometer
– M8 bolts
20 Nanometer
The transmission to the engine
75 Nanometer
Gear shifting lever knot to a floor
6 Nanometer
Cover of the mechanism of the choice of transfers to the transmission
15 Nanometer
Tightening bolt of fastening of a rod of the mechanism of the choice of transfers
15 Nanometer
Bolt in an end face of an entrance shaft
15 Nanometer
Blocking details to an intermediate plate
7 Nanometer
Intermediate plate to the transmission
15 Nanometer
The left support of the power unit to a body
75 Nanometer
The left support of the power unit to the transmission
65 Nanometer
Back support of the power unit to the lower frame
40 Nanometer
The switch of lamps of a backing to the transmission
20 Nanometer
Plate of fastening of the drive of a speedometer
4 Nanometer