Opel Vectra A

since 1988-1995 release

Repair and operation of the car

Vektr's Opel And
+ 1. Maintenance instruction
+ 1.1 Maintenance
+ 2. Engine
+ 3. Repair of DOHC engines
+ 4. Repair of the diesel engine
+ 5. Cooling system
+ 6. Fuel system
+ 7. The fuel and exhaust system of models with system of injection of fuel
+ 8. Exhaust system and system of decrease in toxicity of exhaust gases
- 9. Fuel systems of the diesel engine
   9.2. General information
   9.3. Case of the air filter
   9.4. Accelerator pedal
   9.5. Fuel level sensor
   9.6. Fuel tank
   9.7. Heater of the fuel filter
   9.8. Discharge of water from the fuel filter
   9.9. Filling and pumping of fuel system
   9.10. Check and adjustment of the maximum turns
   9.11. Check and adjustment of turns of idling
   9.12. Electromagnetic valve of a stop of the engine
   9.13. Fuel pump of high pressure
   9.14. Check and adjustment of the moment of injection of fuel
   9.15. Fuel nozzles
   9.16. Turbocharger
   9.17. Heat exchanger
   9.18. Inlet collector
   9.19. Final collector
+ 10. Engine electrical systems
+ 11. Transmission
+ 12. Mechanical transmission
+ 13. Automatic transmission
+ 14. Power shafts
+ 15. Brake system
+ 16. Suspension bracket
+ 17. Body
+ 18. Electric equipment
+ 19. Check of malfunctions

9.18. Inlet collector

PERFORMANCE ORDER

1. Remove a weight wire from the accumulator.

2. Weaken the collars fixing the inlet air channel to a casing of the air filter and remove it from the engine.

3. Weaken collars and unscrew the bolts fixing the inlet air channel of a turbocharger and remove it from a head of the block of cylinders.

4. Unscrew the bolts fixing a heat exchanger air inlet pipe to a collector of a head of the block of cylinders and otsoyed to Nita a pipe from a collector. Weaken a collar of fastening of other party of a pipe and remove a pipe from the engine.

5. Weaken a collar and remove a vacuum hose of the fuel pump from a back part of a collector.

6. Unscrew screws and remove an arm of a plait of wires from a collector.

7. Evenly and gradually unscrew the bolts and nuts fixing an inlet collector to a head of the block of cylinders.

8. Remove an inlet collector together with laying.

9. Check that the interfaced surfaces of an inlet collector and a head of the block of cylinders, pure and dry and establish new laying on collector racks.

10. Establish a collector and, working in the diagonal sequence, evenly and gradually tighten nuts and bolts of fastening of a collector the required moment.

11. Establish an arm of a plait of wires.

12. Connect a vacuum hose of the fuel pump to a collector.

13. Establish a heat exchanger air inlet pipe, using new laying. Tighten bolts of fastening of a pipe and connect an inlet hose.

14. Install inlet channels and connect the accumulator.

15. Start the engine and check tightness of fuel system.