Opel Vectra A

since 1988-1995 release

Repair and operation of the car



Vektr's Opel And
+ 1. Maintenance instruction
+ 1.1 Maintenance
+ 2. Engine
+ 3. Repair of DOHC engines
- 4. Repair of the diesel engine
   4.2. General information
   4.3. The repair which is not demanding removal of the engine
   4.4. Check of a compression
   4.5. Top Dead Point (TDP) of the piston of the first cylinder
   4.6. Cover of a head of the block of cylinders
   4.7. Pulley of a bent shaft
   4.8. Casings of a gear belt
   4.9. Replacement of a gear belt
   4.10. Check and installation of phases of gas distribution
   + 4.11. Mechanism of a tension of a gear belt and pulleys
   4.12. Replacement of a sealing ring of the camshaft
   4.13. Check and adjustment of gaps of valves
   4.14. Camshaft and pushers
   4.15. Head of the block of cylinders
   4.16. Oil pallet
   4.17. Oil pump
   4.18. Replacement of a sealing ring of the oil pump
   4.19. Oil heater
   + 4.20. Pistons with rods
   4.21. Flywheel
   4.22. Replacement of sealing rings of a bent shaft
   4.23. Replacement of support of the power unit
   4.24. Recommendations about removal of the engine
   4.25. Removal and installation of the engine
   4.26. Repair of the engine
   4.27. Start of the engine after capital repairs
+ 5. Cooling system
+ 6. Fuel system
+ 7. The fuel and exhaust system of models with system of injection of fuel
+ 8. Exhaust system and system of decrease in toxicity of exhaust gases
+ 9. Fuel systems of the diesel engine
+ 10. Engine electrical systems
+ 11. Transmission
+ 12. Mechanical transmission
+ 13. Automatic transmission
+ 14. Power shafts
+ 15. Brake system
+ 16. Suspension bracket
+ 17. Body
+ 18. Electric equipment
+ 19. Check of malfunctions


24bec775


4.24. Recommendations about removal of the engine

GENERAL INFORMATION

Prevention

Before removal of the engine read all section on removal of the engine.


On all models the power unit consisting of the engine and the transmission is removed from a motor compartment up.

If you decided to remove the engine for repair, then some preparations have to be made.

The paramount importance has the choice of the venue of works, for providing space for service and storage of spare parts. It is desirable to do it at bus station or in a garage with an equal horizontal floor with a pure hard coating.

Before removal of the engine wash up the engine and a motor compartment. Removal of the engine requires the load-lifting mechanism allowing to lift safely the power unit.

If you remove the engine for the first time, it is necessary to invite the skilled expert. Besides, there are many cases when one person cannot perform at the same time all operations at removal of the engine.