Opel Vectra A

since 1988-1995 release

Repair and operation of the car

Vektr's Opel And
+ 1. Maintenance instruction
+ 1.1 Maintenance
+ 2. Engine
+ 3. Repair of DOHC engines
+ 4. Repair of the diesel engine
+ 5. Cooling system
+ 6. Fuel system
+ 7. The fuel and exhaust system of models with system of injection of fuel
+ 8. Exhaust system and system of decrease in toxicity of exhaust gases
+ 9. Fuel systems of the diesel engine
+ 10. Engine electrical systems
- 11. Transmission
   11.2. General information
   11.3. Coupling cable
   11.4. Adjustment of a cable of coupling
   11.5. Coupling pedal
   + 11.6. Couplings (the engine and the transmission are installed in the car)
   11.7. Coupling (the transmission is removed)
   11.8. Release bearing
+ 12. Mechanical transmission
+ 13. Automatic transmission
+ 14. Power shafts
+ 15. Brake system
+ 16. Suspension bracket
+ 17. Body
+ 18. Electric equipment
+ 19. Check of malfunctions

11.3. Coupling cable

Removal

Removal of the bracket fixing a carving tip of a cable of coupling to the squeezing lever

Fastening of a cover of a cable of coupling on coupling case ledges

PERFORMANCE ORDER

1. Measure length of a carving tip of a cable of coupling acting from the squeezing lever in a motor compartment. This size needs to be used for ensuring the correct installation of a cable of coupling.

2. Remove the bracket fixing a carving tip of a cable of coupling to the squeezing lever and remove a carving tip from the lever (see rice. Removal of the bracket fixing a carving tip of a cable of coupling to the squeezing lever). For simplification of removal move the lever to the engine.

3. Remove fastening of a cover of a cable of coupling from ledges on a coupling case (see rice. Fastening of a cover of a cable of coupling on coupling case ledges).

4. In interior of the car remove the lower panel of finishing in deepening for the driver's legs, then disconnect a returnable spring from a pedal of coupling and remove a coupling cable from a coupling pedal. Keep in mind that the returnable spring also fixes to a coupling pedal a coupling cable. For improvement of access it is recommended to remove a coupling pedal.

5. Through a partition of a motor compartment take a coupling cable in a motor compartment. At the same time do not damage a sealing ring of a partition of a motor compartment.

Installation

PERFORMANCE ORDER

1. Installation is made in the sequence, the return to removal. Establish a carving tip of a cable of coupling so that its vystupaniye from the squeezing lever was same, as well as before removal.

2. Check correctness of an arrangement of a sealing ring in a partition of a motor compartment.